Kawasaki VN750 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
33 Posts
Discussion Starter #1 (Edited)
The left side fit like a glove, all I had to do was rotate the shifter just a little so my foot would slide under with ease. The right side is a little more difficult, had to cut the botton two mounting holes on the floorboard, then I had to add a 1" piece on the break pedal, just cut the pad off and weld the 1" extension on and weld the pad back on. had to tip it about 1/4" towards the back for a more comfortable foot position on the brake. It's not welded yet, I should have it installed tomorrow.
 

·
MANIC MECHANIC
Joined
·
943 Posts
looking good
 

·
Linkmeister Supreme
Joined
·
7,960 Posts
They look good. Could you post some pictures taken straight on, from down level with the shifter. One with it in the original position and a second with it moved up one spline where you have it now. There are 32 splines on the shaft, so a one spline move is just over 11*. How far in inches did you raise it?

I would like to see some tech pics of the mods needed on the right side too.
You should know that we are as interested in the how-to-do stuff as the finished product. <G>
 
1 - 3 of 3 Posts
Top