Kawasaki VN750 Forum banner

1 - 7 of 7 Posts

·
wildman
Joined
·
10 Posts
Discussion Starter #1
worked late last night and got end off of new shifter shaft welded on and got weld ground down and cleaned up!!!!the pic of the shaft has not been ground and cleaned up... i did the weld job and waiting now to hear from my mechanic to see if the side cover went on alright!!!! got my fingers and toes crossed!!!!!
 

Attachments

·
Old Truck Junkie
Joined
·
4,133 Posts
I think that will work good. You may need to use some clear tape over the shaft to protect the oil seal on reassemlby.
 

·
1986 VN750
Joined
·
3,255 Posts
Nice work. I am glad you do not have to split the case and have a workable solution!
 

·
wildman
Joined
·
10 Posts
Discussion Starter #5
hope to have it back on road soon

yeah i got it worked down smooth and measured it and seal will ride about 3/8 of an inch behind weld!! now if my weld holds everything will be great!!!think im gonna coaster it while its all tore down!!!!!!!!! the owner of the muffler shop i manage sells motorcycle parts and accessories, fixin to order me a set of v+h cruzers next week ,i can get them at his wholesale cost for 289.00 !!!!!!! thanks for the encouragement and advice i will post some pics soon!
 

·
Let's Ride!!
Joined
·
606 Posts
How'd you get the side cover off without pulling the engine?
 

·
HAWK
Joined
·
2,576 Posts
If you look he has a hammer stuffed under the motor holding it up. You can tilt the motor and get it off.
 
1 - 7 of 7 Posts
Top