Kawasaki VN750 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I have a VN 92 and it's wiring system was in bad condition, so I bought an used one but in good condition.
Then installed it, all the conections works well, (turn signal, break rear and front, hazzard lights, etc,) but when I start the engine, it works still I pull off the start button. My head will explode :confused:
 

·
Search Goddess
Joined
·
2,002 Posts
I had something like this happen to me when we replaced the pick-up coils during a stator change.
Turns out we corrected it by flipping the plug for the pick-up coils. Trace the pick-up coil wires from the stator cover try switching where they connect. Since you did work on the wiring harness these may have been re-connected backwards.
 

·
Registered
Joined
·
8 Posts
Discussion Starter #5
Excuse my friends, my english is worst :mad:.

The engine works meanwhile (no still) I'm pressing the start button, then, when I release it, the engine stop.
 
1 - 6 of 6 Posts
Top