Kawasaki VN750 Forum banner

1 - 7 of 7 Posts

·
Retired USAF (IYAAYAS)
Joined
·
674 Posts
Discussion Starter #1
I want to order some footpegs to attach to the engine guard that's coming but I don't know the size of the bar its made from.............
 

·
Registered
Joined
·
7,666 Posts
My guess is 7/8", but you can check using open-end wrenches.

Even a tape measure will show close enough, don't use the very end, but between the 1" and 2" marks.
 

·
Retired USAF (IYAAYAS)
Joined
·
674 Posts
Discussion Starter #4
Well, once it gets here I'll measure it and report here.
 

·
Retired USAF (IYAAYAS)
Joined
·
674 Posts
Discussion Starter #5
Just to close this thread out: I received my engine guard today (Thanks Goofin!) and it is made from 1" tubing. So now I can order some footpegs. Probably sometime next week I'll be removing the existing highway peg project, based on a Knifemaker design, and putting it up for sale. When I do I'll start a thread in the SELL section.
 

·
Retired USAF (IYAAYAS)
Joined
·
674 Posts
Discussion Starter #7
Well, I got the engine guard installed. What a pain in the a** !! But it's on. Now to figure out what clamp-on pegs to acquire and to replace the darned right side exhaust gasket because its now leaking.
 
1 - 7 of 7 Posts
Top