Kawasaki VN750 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
49 Posts
Discussion Starter #1
So just a few questions I couldn't find amwsers to when I do this mod what do I use to cut the bike with and also how do I know were/how much to cut also should I just leave the oil in the bike then change it after words and maybe dump some fuel around before adding new oil/filter
 

·
Registered
Joined
·
736 Posts
Typically a rotary tool with cutoff wheel is used, but from some reports around here lately, I'm wary of doing it at all. It's obviously "at your own risk" procedure, and can lead to more headaches down the road if not done properly. Even if done properly it can still give you issues...
 

·
FREEBIRDS MC CENTRAL NY
Joined
·
16,093 Posts
it is best to pull motor and pull sidecase off

Sent from my LGL34C using Tapatalk
 

·
Registered
Joined
·
110 Posts
X2 agree with Doc, pull the engine. That's how I did mine. If I had to do it again, I'd pull it again. Much better than a rebuild!
 
1 - 4 of 4 Posts
Top