Kawasaki VN750 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
458 Posts
Discussion Starter #1
I have to remove my engine to replace my stator. Im to the point where i need to disconnect the drive shaft. The manual says remove the front bevel gear case. is there a way i can just disconnect the shaft and remove the engine with the transmission installed?
 

·
Premium Member
Joined
·
1,766 Posts
Not that I know of. Also found it much easier to put the bevel case on by removing the rear wheel and unloading the spring tension.

Jon
 

·
Premium Member
Joined
·
4,778 Posts
You know it's no longer necessary to remove the engine to replace the stator, correct?
 

·
Linkmeister Supreme
Joined
·
7,960 Posts
1 - 4 of 4 Posts
Top