Kawasaki VN750 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
36 Posts
Discussion Starter #1
Looking for a rectifier plug replacement anyone know of any aftermarket kits available?
 

·
Giggity!
Joined
·
4,307 Posts
I've never seen an aftermarket but you could keep an eye on eBay for a cheep wiring harness.
You could always connect it without a plug. Just crimp & solder new spade connectors.
Use heat shrink on the ends to cover the spades & your good to go.
Not a factory fix, but a fix.
What happened to yours?
 

·
Registered
Joined
·
36 Posts
Discussion Starter #3
Heavily corroded with the white wire rotted off.
 

·
Registered
Joined
·
207 Posts
This may be what you need. I have used the "6P250 CNA Tang-Less Set" before, shown about halfway down on this page. Also, it pays to order spare socket inserts with it.

http://www.easternbeaver.com/Main/Elec__Products/Connectors/CNA250-TL/cna250-tl.html

It pays to use a good barrel crimper, but you can use needle nose pliers; just don't compress too hard or you will "banana" the insert. If you have concerns about corrosion, hit the rear of the socket with solder once it's crimped.

Let us know if it works for you.
 

·
Registered
Joined
·
36 Posts
Discussion Starter #5
Thanks!!
 
1 - 5 of 5 Posts
Top