Kawasaki VN750 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter #1
This may song stupid but how do you remove the electrical connection to the regulator. Is there a pin underneath. Cant move it out for quids and I need to have a look at the connection to see if it is corroded.

Not electrical but when you're adjusting or tightening the manual chain tensioner do you have the engine running and what do you listen for as you tighten it. Got some chain slapping noise (i think).
 

·
Simple Solutions
Joined
·
965 Posts
u have manuals on there ake a pic,,,, but that is how i would do it (note never adjusted one So un sure of proper adjustment.... connection pinch the tab on the bottom up and pull its a pain i had my rr out of the bike to finaly get it to unplug the first time i struggled like u are ... if your goin that far relocate it while your there ... better safe then sorry
 

·
Registered
Joined
·
209 Posts
the connector has a clip on the side, depress and pull firmly.

as for the mcct, hand tighten until contact, start engine slowly turn until clacking is faint or nonexistant. back off 1/4 turn.
 
1 - 3 of 3 Posts
Top