Kawasaki VN750 Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hey all! Long time lurker, first time poster. Ran into an issue the other day with my float on the rear carb, filled with gas through a little pin hole. Been racking my brain on melting, covering etc but now am just looking to replace. I found a replacement housing with both floats on kawi parts house but it’s 6-10 weeks out, and don’t really trust that if I buy a whole carb off eBay that the floats will be good. So out of curiosity, anybody know where to buy just the float?? Searched endlessly online for a couple weeks and did my best to search through the forum before posting but I’m at a dead end. Any hep is appreciated, thanks 🤘
 

·
Registered
Joined
·
9,465 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
I've seen some, will try to think of where.

Would the pinhole seal if you rubbed it with a soldering or wood burning iron?
I tried this and thought I was successful, for about ten miles at least.. then tried again but got too ambitious and put a bigger hole in it, at this point I’m just gonna replace em both and Lee the good one as a back up
 
1 - 5 of 5 Posts
Top