Kawasaki VN750 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
203 Posts
Discussion Starter #1
I am looking to replace my handle bars. I am thinking of going bigger diameter. Does anyone know of a kit to change the handlebar brackets?
 

·
and the Adventure Cycle
Joined
·
6,141 Posts
I know there's a kit to make 'Fat Bars' (tapered handle bars on dirtbikes) fit a standard 7/8 mount and raise the bars about an inch or so, but I haven't really looked at the bars on the Vulcan to see if they might work there.

You can see them HERE. (I think the fat bars are 1in at the center section)

I'll check it out tomorrow and see if it looks like they'd work.

EDIT: I just checked the Pro Taper website, and believe the bars for those mounts are 1-1/8in. , not 1in.
 

·
85 VN 700
Joined
·
1,033 Posts
Not to state the obvious, but you did think about the fact that you'll have to change everything (grips, switches, etc.) which is not an inexpensive proposition (and you have hand controlls listed in your mods).

Seems like I've seen a number of handlebar mounts which should fit...
 
1 - 3 of 3 Posts
Top