Kawasaki VN750 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
721 Posts
Discussion Starter #1
ok, I am going to marble today..
I just want to make sure I got the right hoses...
Here's the right side/front cylinder:


and the left side/rear cylinder:


put the marble in just at the end of each hose and I'm good right? and then adjust the air mix screws... Correct me if I am wrong, thanks!
 

·
Old Truck Junkie
Joined
·
4,133 Posts
Shove the marrble into the hose and reconnect the hose. Adj. fuel mix and you should be okay.
 

·
Registered
Joined
·
721 Posts
Discussion Starter #3
the hose doesn't want to come off to put the marble in.. Any ideas?
 

·
Old Truck Junkie
Joined
·
4,133 Posts
Remove the clamp and then take a pair of pliers and without damaging the hose, twist the hose to break the seal. This should make it come a loose.
 

·
Old Truck Junkie
Joined
·
4,133 Posts
where are the fuel mix screws located...are they the little straight blade screws that i see near the bottom on the carbs?
james
You may have to remove the lead plugs that covers them so that you and I won't mess with them.
 
1 - 8 of 8 Posts
Top