Kawasaki VN750 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
579 Posts
Discussion Starter #1
pmassey sent me this link and he built them for his new vn1500. They seem to be easy but they mount on the fork part that slides but doesn't matter as they are upside down forks. Will these work on our bike even though they will mount on our forks that could possible hit the seals.

Anyone ever done this or have any suggestions?
 

·
FREEBIRDS MC CENTRAL NY
Joined
·
16,076 Posts
Those are not upside down forks. They are fork covers that the windshield is mounted to.they cover the upper tubes and are larger than the lowers so they slide up in
 

·
FREEBIRDS MC CENTRAL NY
Joined
·
16,076 Posts
Could probably adapt a set of fork covers to work
 

·
Registered
Joined
·
151 Posts
He says he has buffeting and it is blowing his helmet to the point it is trying to come off. Bear in mind he does not have a windshield. I made those lowers for mine for right at $35. They work great. Used 1/4 in plexiglass and the 'P' clamps I ordered from Marsh Fasteners just like the link shows. The most expensive thing was the shipping for the 'P' clamps. They look good and again, work great.
 
1 - 7 of 7 Posts
Top