Kawasaki VN750 Forum banner

1 - 11 of 11 Posts

·
Premium Member
Joined
·
968 Posts
Discussion Starter #1
ok need opinions, Im planning on doing KM's dash set up but instead of stainless steel im going to use plastic from a cutting board. im leaning towards the black with specks because of the contrast and its 1/4 inch thick.
just need to hear some input

 

·
Registered
Joined
·
1,021 Posts
That's a pretty good idea. You could also go with various colored boards that would complement bike's color scheme. I like the black specked one though. Have you thought how you are going to finish the ends after the cuts are done?
 

·
Premium Member
Joined
·
968 Posts
Discussion Starter #6 (Edited)
That's a pretty good idea. You could also go with various colored boards that would complement bike's color scheme. I like the black specked one though. Have you thought how you are going to finish the ends after the cuts are done?
im using a band saw with a 24 tooth fine blade so the edges should be smooth, if not i may have to use some 800 paper on them


the black cutting board was found at kmart for 10 bucks.i was going to use 1/4 inch clear polycarbonate but it was too pricey and wasnt sure what to use to cut it.
 

·
Registered
Joined
·
1,021 Posts
I think that will look pretty nice!
 
1 - 11 of 11 Posts
Top