Kawasaki VN750 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I have added driving lights and light bar, but I am concerned about the "questionable" electrical system on the Vulcan. Any comments about wattage that I should watch out for? I will be using 25watt halogen bulbs (not sealed beams). Appreciate any suggestions and comments.
 

·
Old Truck Junkie
Joined
·
4,133 Posts
I ran two 55 watt driving lite made for a car for a few months along with 80 watt high beam. I never had any problem, however, most of my driving is on the open road at higher speed. And also I ussually used them only at nite when needed. Now I have 35 watt sealed beams, and try to remember to turn them off when I stop and put my low beam on. This way I have the least electicity used when starting up.
 

·
and the Adventure Cycle
Joined
·
6,141 Posts
At 25 watts each, ya should be OK.
But like stated above, if you use then when you NEED them, not just to have them lit up, it's even better.
 

·
Premium Member
Joined
·
1,766 Posts
Don't parade ride or idle a lot and you should be fine. Over 2500 rpm's, you have all the power you need.

Jon
 

·
Registered
Joined
·
10 Posts
Discussion Starter #5
Thanks all for the info,I will watch the rpms and when I use them
 
1 - 5 of 5 Posts
Top