Kawasaki VN750 Forum banner
1 - 2 of 2 Posts

· Registered
2001 VN750; 2011 VN1700
Joined
·
19 Posts
Discussion Starter · #1 ·
Replacing rod bearings and crankshaft on a '01 VN750 with 6,736 miles. Clymer manual (pg 248, #12) says "Slide the two washers on (Figure 60).". Problem is that I don't have two washers lying around, and even Partzilla doesn't show two washers at the end of the countershaft after 1st gear (next to the right side case). The main shaft does have two washers against the left side case, but I have nothing at the opposite side of the gear train .

Anyone had the same problem? What am I missing?
 

· Registered
2001 VN750; 2011 VN1700
Joined
·
19 Posts
Discussion Starter · #4 ·
Thanks flitecontrol. I have that manual as well and there's no mention of it there. Exploded parts diagram (either manual or Partzilla) doesn't show washers there, either. I may just cross that line out of my manual...?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top