Kawasaki VN750 Forum banner

1 - 5 of 5 Posts

·
Dr. Vulcanstein
Joined
·
1,536 Posts
Can you take pics of the bottom of the seat pan? Is there a tounge on the front lip of the seat? If its too wide you can trim it to slide into the groove near the fuel tank. Take your stock seat off and let the other seat just rest there to get a visual. If they dont align well you can use a heat gun ($5 bucks at HF) to form the seat pan. Take the fabric and padding off, its real easy to put back on.

As far as the engine gaurd, see if the lower yolks and the top bracket line up with anything on the bike. If not ide invest in a welder and make almost anything possible.
 

·
Registered
Joined
·
21 Posts
Discussion Starter #3
I'll pics tomorrow jada
 

·
Banned
Joined
·
10,354 Posts
If ya get stuck, ship em to me and I'll mod them for a minimal fee...youll need extra brackets for the crashbar welded on, and the seat needs a tab in front, and bracket in rear.
 
1 - 5 of 5 Posts
Top