Kawasaki VN750 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter #1
I just recently got my 89 vulcan, and had to order gauges,previous owner removed speedo and tach. So when I got my new ones installed them but I have a slight problem now They sent entire cluster, with 3 pin connectors, a 9 pin a 6pin and a 4 pin however I can't find a 4 pin connector in the bike harness Can anyone help?
 

·
Registered
Joined
·
722 Posts
I just went and checked out my 89 Thinking I might be able to help you out.My harness runs from the guages to the headlight housing were they connect to the main harness.But the pin connectors are different I have a 9,5 and 2 set up on mine.If they are not in the headlight housing,have you checked to see if the P.O. pulled them back up under the gas tank or something like that?
 

·
Registered
Joined
·
748 Posts
Sounds like you got the guages/harness for the earlier bikes; I think the 4 pin is for the speedo lights and distance sensor for the turn signal cancelling setup, if it's coming out of the speedo. The two-pin would be just speedo lights.

Did you order by year model, or by the VIN number?

Jim
 
1 - 5 of 5 Posts
Top