Kawasaki VN750 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
i have a 1997 vn750 in stock mint condition. i just ordered new V&H pipes, im wondering if i have to do anything to the carbs? thanks in advance. im in south florida at sea level.
 

·
Senior Member
Joined
·
2,526 Posts
You should only need to re-jet if you get rid of the stock filters and put on those pod filters. Install the exhaust and go for a ride.:motorcycl
 

·
Registered
Joined
·
796 Posts
Putting these pipes on doesn't require re-jetting but you will hear more popping at decel so coastering it and turning the air/fuel screws out to 2.5 turns will stop the popping considerably.
 

·
Registered
Joined
·
22 Posts
Discussion Starter #4
and where exactly is this screw located you speak of?
 

·
Registered
Joined
·
796 Posts
If the carbs have never been adjusted the screws are protected by a factory plug. Both plugs are just under the vent hose on each carb. There is a wright up about how to do this procedure in the versus threads in the carbs section/reduce popping threads.

http://www.vn750.com/forum/showthread.php?t=1083
 

·
Registered
Joined
·
796 Posts
Sorry. Yes they are vac hoses. Had a brain fart there. lol
 

·
Registered
Joined
·
22 Posts
Discussion Starter #8
Alright thanks for the help again. i can get an idea from the versus thread but some pictures would help to be exact, but ill just fit the new pipes on first and see what happens before i go altering the carbs.
 
1 - 8 of 8 Posts
Top