Kawasaki VN750 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1 (Edited)
what size are our banjo bolts?

i know it takes a 12mm socket but what are the threads....

lookinf to build custom lines and need to know
 

·
Linkmeister Supreme
Joined
·
7,960 Posts
Well that`s a question I haven`t seen asked before in the 3 1/2 years I have been on this board.
Have you checked a schematic diagram on a dealer site like Bike Bandit, or the down loadable Kaw service manual to see if the bolt is identified and sold separately?

Here is link to the diagram, but the bolt size is not specified. Sorry.:(
http://www.bikebandit.com/houseofmotorcycles/1991-kawasaki-motorcycle-vulcan-750-vn750a7-us/o/m4555#sch50549

Anybody have a master cylinder off the bike and can check banjo bolt thread size for LD?
 

·
Super Moderator
Joined
·
11,928 Posts
I'm about 89.9 % sure they are 10mm X 1.5" threads. But I think they are two different thread sizes too.

Pretty sure all metric fittings are the same diameter and there's like 3 different sizes in American fittings.

As the bike is metric, I'd put my money on them being 10mm...:)

If someone knows different, fill us in. Sorry, been awhile since I dealt with this.
 
1 - 3 of 3 Posts
Top