Kawasaki VN750 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Hey Everyone,

I just pulled off the rear end of my Vulcan; a large amount of rusty dust was bathing the spline in the coupling for who knows how many miles. I'm ashamed I didn't pull it apart sooner.

On the positive side of things, only the coupling appears to be worn out. The final drive splines look good (enough) to go.

Anyone have a best priced source for parts?

So, just another reminder - check your splines if you haven't already.

-Andrew
 

·
Premium Member
Joined
·
4,778 Posts
I've got a driveshaft, but I just offered it to someone who may or may not need it on another thread. PM sent.
 

·
Registered
Joined
·
409 Posts
I have a drive shaft as well. PM me if you need one.
 

·
Old Truck Junkie
Joined
·
4,133 Posts
Just in case you don't know. The splined coupler can be removed from the rear part of the drive shaft.
The whole drive shaft does not need to come out. It will take some snap ring plier for removal.
 
1 - 4 of 4 Posts
Top