Kawasaki VN750 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter #1
Hi everyone,

I have V&H cruzers, and I'm experiencing the popping/backfiring.

In the Vulcan Verses, the "air mix screw" is mentioned several times. I looked through chapter 2 of the Kawa MSM, and I didn't find the words "air mix screw." What are these screws called in the MSM?

Thanks,
ACS
 

·
Premium Member
Joined
·
3,505 Posts
In Clymer's they're labled as "pilot adjust screws." They may also be called "fuel mixture screws" since they regulate the balance of fuel/air going into the carbs. They're located under the vacuum port (brass nipple) on each carb - if you have trouble seeing 'em, could be that yours are still covered by the lead plug that has to be put over 'em at the factory.
 

·
Registered
Joined
·
14 Posts
Discussion Starter #3
In Clymer's they're labled as "pilot adjust screws." They may also be called "fuel mixture screws" since they regulate the balance of fuel/air going into the carbs. They're located under the vacuum port (brass nipple) on each carb - if you have trouble seeing 'em, could be that yours are still covered by the lead plug that has to be put over 'em at the factory.
Got it. Thanks.

Now I just need to buy a smaller screwdriver.

-ACS
 
1 - 4 of 4 Posts
Top