Kawasaki VN750 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
143 Posts
Discussion Starter #1
I pulled my carbs off today and accidentally broke the threaded end of the idle/air mix screw/knob... Any idea where I can find a replacement at? Perhaps one that would cost less than buying from Kawi?
 

·
Simple Solutions
Joined
·
965 Posts
I pulled my carbs off today and accidentally broke the threaded end of the idle/air mix screw/knob... Any idea where I can find a replacement at? Perhaps one that would cost less than buying from Kawi?
theres probably one floatin around here but the only knob on there is the idle set knob it puses on the back of the throttle plate
 

·
Registered
Joined
·
143 Posts
Discussion Starter #3
Cheapcycleparts.com calls it a Screw-Throttle Stop... It is a knob that comes by the rear carb, a few inches aft of the pet cock, that you twist to make the idle richer or thinner... The threading end is what broke, but it is one whole piece, so, I need the whole new piece to replace it.
 

·
Registered
Joined
·
143 Posts
Discussion Starter #4
The manual calls it the "Idle Adjuster"...
 

·
Premium Member
Joined
·
3,027 Posts
All that knob does is adjust idle speed, not mixture. The pilot screws adjust the mixture. The thing to do is get a whole new unit from cheapcycleparts or bikebandit. Jerry.
 
1 - 6 of 6 Posts
Top