Kawasaki VN750 Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
1,021 Posts
Very nice! Looks very comfortable.

I have a Mustang seat that was on my bike when I bought it. Can't complain.
 

·
Registered
Joined
·
17 Posts
Looks good. How about a few shots of the mods you did under the seat?
 

·
Registered
Joined
·
11 Posts
Discussion Starter #4

·
Registered
Joined
·
196 Posts
I think that this is my favorite 900 seat mount style, looks nice and clean.
I like the taco you have in that last pic also reminds me of one of my dads old ice racers.

Sent from my SAMSUNG-SGH-I997 using Motorcycle.com Free App
 

·
Premium Member
Joined
·
1,021 Posts
Quick question. I just performed the seat mod with the plate and bolt through the fender. How do you stop the bolt from turning when removing the seat? Seems like after sometime, the bolt and nut will become harder to remove, then the bolt will move with the nut.

Thanks
 

·
Registered
Joined
·
1,623 Posts
My seat in the picture above was done with a fender washer and a lock washer above and below the plate. Lock washer at the bolt head and at the nut with fender washers at both sides of the plate. Also used lock tight at the nut. It ain't goin' nowhere! The bottom nut under the seat fits in the hole of the cross brace so it doesn't get in the way, sturdies any side to side movement though.
 

·
Registered
Joined
·
1,623 Posts
Don't know anything on how you mounted your seat but here is a picture of what I did to support the seat so it sat firmly in place. Made a new tongue mount from 1/2 square tubing and split pvc pipe and put around the frame crossbrace.
 

·
Premium Member
Joined
·
1,021 Posts
Thanks.
 
1 - 10 of 10 Posts
Top