Kawasaki VN750 Forum banner
Cancel

Search Results for ‘timing’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 5 Results

Search Tags

750 acct aftermarket air box air filter backfire backrest battery bobber brake brakes carb carborator carbs carburetor charging charging problems choke chrome clutch clutch cable coolant cooling cruzers custom driveshaft ear shave earshave electrical electrical problem engine exhaust filter final drive for sale frame mod. fuel fuel lines gas gas tank handlebars headlight help needed idle ignition intake junction box kawasaki kawasaki vulcan 750 leak luggage rack mcct mod mods muffler new member new rider newbie oil oil leak paint parts petcock poogs power project r/r radiator rebuild rectifier relay repair seat seats spark spark plugs speedometer spline stalling start starter starting starting problem stator suspension switch throttle thu mua phe lieu timing transmission turn signal turn signals vance and hines vn700 vn750 vulcan vulcan 750 windshield wires wiring
  1. Electrical
    Whenever I crank the engine, the front plugs fire at the wrong time and the engine kicks back/blows air out the carb intakes. (valves/compression/timing has already been tested). I got a new ignition coil, and while it got slightly better, it still happens while cranking/ low RPMs. After...
    coil timing wiring
  2. Carbs & Fuel System
    Hey everyone, I have a very strange issue with the front cylinder of my 1990 Vulcan. When I try and start the bike, after a few cranks, there will be a loud noise followed by a faint bit of smoke/air forcefully shooting out the intake on the carbs. The engine will also kick back and temporarily...
    blowback carb timing
  3. Electrical
    Im about to put my pickup coils back into my cover, but I forgot to mark which one was where when I removed. Does it matter or can they go in either place? Is there anything I should pay attention to when screwing them in, or do the screws automatically place them with the proper clearance...
    ignition pickup coils timing
  4. Electrical
    I recently had to replace the cams in my bike, a 2005 vn750 and I got the thing running but when I took it out to ride it completely cuts out at 4000rpm. I thought I had the cams in wrong, but pulled the engine again and checked. They were off one tooth on one cam so I fixed it and when I...
    cams retarding timing
1-4 of 5 Results
Top