Kawasaki VN750 Forum banner
Cancel

Search Results for ‘rod’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

750 acct aftermarket air box air filter backfire backrest battery bobber brake brakes carb carborator carbs carburetor charging charging problems choke chrome clutch clutch cable coolant cooling cruzers custom driveshaft ear shave earshave electrical electrical problem emissions engine exhaust filter final drive for sale frame mod. fuel fuel lines gas gas tank handlebars headlight help needed idle ignition intake junction box kawasaki leak led luggage rack mcct mod mods muffler new member new rider newbie oil oil leak paint parts petcock poogs power project r/r radiator rebuild rectifier relay repair seat seats spark spark plugs speedometer spline stalling start starter starting starting problem stator suspension switch throttle thu mua phe lieu timing transmission turn signal turn signals vn700 vn750 vulcan vulcan 750 windshield wires wiring
  1. Engine / Exhaust / Cooling
    Thank you all for your replies. I was able to get the rod (pn 39110) in without splitting the case open with the help of my father in law " The great one " with removing clutch and stator and of course it being a 2 man job and A LOT of patience was able to remove the broken rod from a small hole...
    39110 broken rod shifter tie
  2. Engine / Exhaust / Cooling
    I have a 1999 750. I had the carbs off and cleaned. The plugs changed. It only has 26000 miles on it. I bought it from a guy that left it sitting out side for two years. ( what a dummy). Any ways i rescued it. Believe it or not It looks beautiful. I finally got it running. The day after I got it...
    cam chain engine push rod rod
1-2 of 2 Results
Top