Kawasaki VN750 Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Transmission & Rear End
    One of the gaskets on the bevel gear output shaft on my bike is leaking from the bottom. It appears to be the innermost gasket that I’m pointing to in the picture. Now taking the bevel gear off the engine is no problem I’ve done it a couple times now. But my question is, to replace the gaskets...
  2. VN750 General Discussion
    Recently changed the oil in the bike and, as was recommended here, filled to leave only a small bubble in the sight glass. I’m probably about 400 miles in since the change, and I noticed some small drops of oil under the bike after riding today. My first thought was blowback, but looking under...
  3. VN750 General Discussion
    My 2003 VN750 has an oil leak. I haven't been able to pinpoint it. It only leaks when its running and warm. The oil seems to be coming from underneath the left side of the engine. Is there a place where it is a typical leak on these? Does the engine have to be pulled to fix the problem? Am I...
  4. Engine, Exhaust & Cooling
    So I've identified a small oil leak coming out of the chrome L-bend pipe on the right side of the engine case. See the picture below (not my engine, just found the picture to use as reference). The oil seems to just be bubbling up out of here a little bit at a time. Has anyone had a leak here...
  5. Engine, Exhaust & Cooling
    I seem to be in need of help otherwise I wouldnt be here obviously. My 2002 Vulcan 750 seems to have a decent oil leak going on. I see oil from the front of the engine. Also, now it is backfiring and spitting when I ride it. (like a compression problem). I would like to try to fix this myself...
  6. Engine, Exhaust & Cooling
    I have a minor oil leak that is becoming increasingly more of a problem. I can't pinpoint where the leak is coming from quite yet, but I suspect the 2 hoses coming out of the rear end of my clutch cover. All pictures are on the left side of the bike. Has anyone seen this or have recommendations...
  7. Electrical
    I've tried putting my side outer stator cover on twice now, but still have two oil drips from the bottom of the cover. I can't bare taking the damn thing off again and spending two hours cleaning all the silicone off. Does any one think it would be possible to seal it in this spot from the...
  8. Engine, Exhaust & Cooling
    I took my bike to a mechanic because I was traveling on business on the Vulcan and didn't have the time or facilities to repair it. The guy replaced my stator by cutting through the frame and used a cardboard gasket. I will have to address that later. Here's my problem, though: The gasket is...
1-8 of 8 Results
Top