Kawasaki VN750 Forum banner
Cancel

Search Results for ‘mosfet’

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-2 of 2 Results

Search Tags

750 acct aftermarket air box air filter backfire backrest battery bobber brake brakes carb carborator carbs carburetor charging charging problems choke chrome clutch clutch cable coolant cooling cruzers custom driveshaft ear shave earshave electrical electrical problem engine exhaust filter final drive for sale frame mod. fuel fuel lines gas gas tank handlebars headlight help needed idle ignition intake junction box kawasaki kawasaki vulcan 750 leak luggage rack mcct mod mods muffler new member new rider newbie oil oil leak paint parts petcock poogs power project r/r radiator rebuild rectifier relay repair seat seats spark spark plugs speedometer spline stalling start starter starting starting problem stator suspension switch throttle thu mua phe lieu timing transmission turn signal turn signals vance and hines vn700 vn750 vulcan vulcan 750 windshield wires wiring
  1. Electrical
    My first winter with a Vulcan is coming up and I was looking at doing the R&R replacement with a Mosfet regulator. I was looking at how it tied into the junction box and realized I might as well just deal with both in the same project. I found this thread...
    junction box mosfet r&r
  2. Electrical
    Looks like I'm going to have to install a stator and a rectifier! Both failed tests. Anything I should do while I'm inside replacing stator? What else will I need as far as gaskets and stuff goes? Also should I go MOSFET for the rectifier instead? I've heard guys going that route. Any...
    mosfet rectifier stator
1-2 of 2 Results
Top