Search Results for ‘driveshaft’

Good day to everyone. I have a 2004 Kawasaki Vulcan 750 with 12500 miles. just bought it 3 months ago. Of course I read about the final drive splines getting shot if unlubed. Of course I didn’t do it even tho it says it takes 15 minutes to remove the rear wheel and thus the four bolts holding...

I finally got outside and determined that my splines are definitely shot-- diagnosis correct. I'm having trouble with the circlips holding the couplings in place (on the original and on the replacement shafts). What is required to take the driveshaft out now that I have the rear wheel off? Does...

Hello all, I am trying to remove the coupling from a used driveshaft to replace the one on my bike, which is shot but am having a bear of a time getting the circlip off. I even bought the Klein pliers referenced in the spline lube procedure and even with the driveshaft on my lap, in a well lit...

I have a 92 vulcan 750 and the driveshaft crapped out. Was quoted 1000 bucks to fix and replace, i bought the bike for 2000. Would it be cheaper/better to 1. replace, 2. engine and tranny swap off another bike (if so how much in labor cost) 3. just part it out and sit in tears

Can anyone tell me how I can remove the swing arm from the frame. (and also disconnect the drive shaft joint from the gearbox) I'm rebuilding a VN750 but I can't find out how the swing arm it is fixed to the frame. I already took the 14mm nut & 3 allen head screws off both sides but I can't get...

If anyone has any for sale please let me know. I have a 1998.