Plexifairing 3 Again...
Well got this re-adjusted and seated to where it doesn't hit/interfere with anything. But, I tell ya, I hate looking through it. I measured off 2" and drew a thin line and still found it too tall. Measured off 3" and it was close to what I could live with.
Mind you I'm 5' 8" tall and I can't stand looking through any shield. As it is in the original, I only felt air coming through top vent of my full face helmet, it was hot. I'll try to keep the cut to where the air hits/flows over the the bridge of my nose. But, I'll be god damned if I don't want to lop off 4" of this shield.
My brother-in-law is coming over with a rotary cutting machine/tool next week.
Wish me well, I'll need it. Ha ha...
This is gonna be one short Plexifairing 3
I'm only 5'9" and a bit of a sloucher, yet cutting down the shield just 1.5" did the job for me. I encourage you to experiment with lowering the shield, using the adjustable brackets, before cutting off the full 4"! I'm with you ~ I don't like looking through the shield, especially since the optics in the top center of the PF3 are not clear. On the other hand, when I ride in the winter, I'll put up with it a little distortion to stay warmer behind the plexiglass!
|All times are GMT -4. The time now is 09:18 PM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.