||08-23-2009 08:41 PM
Just replaced my rear carb fuel/mixing screw
Now when I had the carbs out I set both the screws to 2 turns out. Got everything hooked back up and started it. Sounded great, so I left them there and took it out for a spin (about 2 miles). Ran good too, execpt for when I stopped at the light up the street it stalled. Hit the starter and it starts & stalled unless I keep on the throttle. If I turned the Idle screw up to keep it running, and give it gas, it seemed to hold high rpm's (around 3,000) for a few seconds before it came down. Turned both side in about 1/2 turn more and it seemed better, but on my last run it stalled again (idles too low). Any suggestion for where I should start tomorrow?