Turn Signal Relocation
A VROC member asked me in my private e-mail how I did my rear TS relocation shown in my post #36662. Well, Vince , it was pretty simple. I removed the rear turn signal units from their original locations by removing the hold down bolts and disconnecting the electrical connections. The turn signal units have a knob (for lack of a better name) sticking out the bottom of them. I cut these off using my Dremel tool. I removed the tail light assembly, drilled a hole on the left and right sides of it to match the original hold down bolt size. I then used the original TS bolts to secure the TS units to the tail light unit. I had to splice the TS wires because the relocation left them a little too short. I hope this explains things
|All times are GMT -4. The time now is 10:33 AM.|
Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.
User Alert System provided by Advanced User Tagging (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.