|Topic Review (Newest First)|
|04-24-2008 12:18 PM|
|B K R||Some members here had hooked up HID's so them may chime in soon as where they hosted the ballast... IIRC Diaana was one of them|
|04-24-2008 09:02 AM|
|Elemental||Solder would be superior. Crimp connections often fail in high vibration enviornments. Solder, done correctly, is stronger then the wire.|
|04-23-2008 11:17 PM|
|thetravo||yes that is a concern of mine. However I am not so sure where else I should put the ballast. Another concern that I had was also if I do add wire extentions, would the solder be ok or would I have to get connectors and crimp them on??|
|04-23-2008 06:22 PM|
|B K R||Aren't you concerned about the heat from the GB detoriating the ballasts ???|
|04-23-2008 10:33 AM|
Solder a spine in line?
Is there something unusual about the wires?
|04-21-2008 12:33 PM|
HI again. Well I was just wondering if anyone who installed HID headlights into there bike had lengthened the wires. Once I relocated the R/R, I decided that I could place the HID balast there underneath the battery Case. Now all I need to do is lengthen the three wires coming from the HID conversion Bulb to the balast harness. what would the best way to go about doing this? Thank Again!!