Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums - Reply to Topic
Carbs and Fuel System
From the gas tank to the carbs
All fuel system discussion

Thread: hard starting, starting on one cylinder Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

Once registered, your User Name"cannot be changed". We can make exceptions within 7 days, but after that, it is set in stone.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
07-30-2019 10:36 PM
Spockster Complicated, really? Takes too long?

Not hard on the starter, it's actually the prescribed way to use a starter. Long cranking is what's hard on the starter.
07-30-2019 10:31 PM
VN750Rider/Jerry Yes it works, but too complicated, takes too long, and is hard on the starter. If I can get both float bowls full, it will start right up as soon as I hit the starter button. Now to find the thread on the TW conversion. To bad that original petcock with the prime position is no longer available. An alternative (at home) would be to pull the vacuum hose off the front carb and apply vacuum to it for a few seconds.
07-30-2019 09:34 PM
Spockster Bump and Pause, I forget exactly what Paulywog called it.

If you know it's going to be a dry start, crank the starter for a few turns to make some vacuum, pause and give the fuel time to flow a bit. Rinse, repeat, can take few times if the carbs are dry. Works for me.
07-30-2019 09:17 PM
VN750Rider/Jerry
hard starting, starting on one cylinder

I have had this issue now on 3 Vulcan 750s. I believe I now know why it happens. I have been starting the engine up and letting it idle for a while every once in a while on my '97, even though it is not yet rideable. I notice that if I start it every day, it fires right up and runs smooth. But if I let it sit for several days before starting it, it takes a lot of cranking to get it started, it will often backfire a couple of times, and often starts up on the front cylinder only. I have had this issue since 1993, for almost 200,000 miles. It finally dawned on me what may be causing it. While sitting, the gas evaporates out of the float bowls (ethanol gas evaporates even faster than real gas) and because it has a vacuum petcock, it can take some time to fill the float bowls back up again, as gas only comes out while the engine is being cranked. And apparently the front float bowl fills up first. It starts up on the front cylinder, then about 10 seconds later the rear cylinder kicks in. Recently after it had been sitting for about a week, I put a small amount of gas into the carbs through the float bowl vent hose. It fired right up and ran fine. I am definitely getting rid of that vacuum petcock (it's too bad they removed the "prime" position, it should have been obvious it was there for a reason) and going to a TW200 petcock.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome