|Topic Review (Newest First)|
|06-28-2017 03:31 PM|
Originally Posted by vnnikolouzo View Post
And as far as it being useful, I totally agree, but it or my harley pipe setup must go and it lost the coin toss Plus, I have a bike jack I use when I work on it. Thanks all for the help.
|06-28-2017 02:10 PM|
|Goofyfoot2001||Oh man, that center stand is the one thing I miss most about my Vulcan. If I could put one on my sporty I would! So freaking handy to have.|
|06-28-2017 01:51 PM|
|vnnikolouzo||open stand and put coins between spring to releave tension,take off safty pin,loosen bolts and push out axle inside c/stand|
|06-27-2017 11:32 PM|
remove bolts,take off
Sent from my LGL34C using Tapatalk
|06-27-2017 10:50 PM|
Please help removing centerstand
I put harley pipes on my bike and took the goats belly off. The centerstand now hits one of the mufflers instead of the bottom of the goats belly. I put a piece of high temp silicone rubber hose with a zip tie around the centerstand where it rests on the bottom of the muffler. It works perfect but it has reduced my ground clearance and today it bottomed on a speed bump.
Can anyone please tell me the procedure for removing the centerstand ? I searched the forum and could only find posts saying it was a bitch to get the spring back on to re-install it but no thread on removing it. I just don't want to take it off wrong and I don't see how it comes off. Thanks for any help