Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums - Reply to Topic
Where does this wire go?
Includes Electrical mods, Lights, Stator,
Rectifier, Diagrams, etc

Thread: Bike won't start Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

Once registered, your User Name"cannot be changed". We can make exceptions within 7 days, but after that, it is set in stone.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
06-01-2017 12:49 PM
Goofyfoot2001 It's still your ignition switch today too.
06-01-2017 12:12 PM
Nitrospaz9 With mine I had to turn the key just a little before on or it wouldn't get power lol. These bikes are very picky
05-31-2017 08:24 AM
Goofyfoot2001 It is stil;l your ignition switch and maybe it isn't pressing together well. I superglued and tie wrapped mine.
05-30-2017 04:08 PM
majdsaster Similar to an event with my bike a couple of weeks ago. Here's the write-up from my post about re-locating my rear turn signals;

After checking to make sure the tail and brake lights and both new turn signals were working, I pushed the start button and nothing happened. "Dang It... What now?!

I had taken the brake and clutch handles off and cleaned them up on the wire brush of my bench grinder, so I decided this must have something to do with the clutch safety switch.
When I first got this bike I noticed that I didn't have to pull in the clutch to start it.
It looks like the plastic pin that the clutch handle pushes in was broke off, so the switch is always in the start position. I unplugged the wire harness from the switch to remove it from the bike and found the two tiny (#2 screws) that hold this switch to the underside of the clutch were seriously rusted and I almost messed them up but finally got them to turn.

Using a test meter I found no continuity between any of the three terminals of the switch so I opened it up and all of the contacts had corrosion on them. After cleaning everything up I got good readings on the meter and plugged the switch back onto the line and the bike started up just fine. Back to Home Depot where I got some stainless steel, #2x14mm, beveled head screws and reattached the switch into its place under the clutch lever and I was on my way.
05-30-2017 02:33 PM
Bike won't start

Recently bike will not start. I was out riding, stopped by a friends to say hello. Bike was running fine when I turned it off. Turned the key on to leave and no power to lights, horn, starter button. Took apart ignition switch had to re-solder a couple of wires. Bike still won't power up. Checked battery-(good). Fuses-(good). Checked grounds, battery to chassis and chassis to engine-(good). Any help would be very appreciated, Thank you.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome