|Topic Review (Newest First)|
|02-18-2017 06:31 PM|
|Chris and Shim||Well, I got the engine guard installed. What a pain in the a** !! But it's on. Now to figure out what clamp-on pegs to acquire and to replace the darned right side exhaust gasket because its now leaking.|
|02-14-2017 10:28 AM|
Originally Posted by Chris and Shim View Post
Told ya so.....
|02-13-2017 08:24 PM|
|Chris and Shim||Just to close this thread out: I received my engine guard today (Thanks Goofin!) and it is made from 1" tubing. So now I can order some footpegs. Probably sometime next week I'll be removing the existing highway peg project, based on a Knifemaker design, and putting it up for sale. When I do I'll start a thread in the SELL section.|
|02-11-2017 01:49 PM|
|Chris and Shim||Well, once it gets here I'll measure it and report here.|
|02-11-2017 12:13 PM|
My guess is 7/8", but you can check using open-end wrenches.
Even a tape measure will show close enough, don't use the very end, but between the 1" and 2" marks.
|02-10-2017 09:40 AM|
|Knifemaker||I thought it was 1"... but I can't find anything that agrees with that.|
|02-10-2017 01:45 AM|
|Chris and Shim||
What size bar is used in the engine guards?
I want to order some footpegs to attach to the engine guard that's coming but I don't know the size of the bar its made from.............