Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums - Reply to Topic
Electrical
Where does this wire go?
Includes Electrical mods, Lights, Stator,
Rectifier, Diagrams, etc

Thread: Simple Plug Wire Question Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

Once registered, your User Name"cannot be changed". We can make exceptions within 7 days, but after that, it is set in stone.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
03-23-2015 05:36 PM
Godfree Thanks! I had a feeling there was a pin of some sort inside that protruded in to the wire.

I have to assume that the wires are original (1985) The bike only has about 4700 miles on it, but the wires are 30 years old I'm guessing. I'm going to check the plugs as well. I'd like to switch to new iridiums, but I would think the ones on there might look fine. Need to give all the rubber a good once over as it's probably all original.
03-23-2015 05:05 PM
mrseedsower I never replaced the wires on these coils but I have on other bikes. I don't think the wire needs to be anything but cut flush as it is only a one wire operation. There should be a pin sticking out of the coil that the wire goes on to and when you screw the cap back down it tightens it again that pin.

Other on this forum may know more but as far I know, you can go with a flush cut. Pay attention to how the old wires are when you pull them out.
03-23-2015 02:49 PM
Godfree
Simple Plug Wire Question

Hey Guys,
I browsed quite a few threads and didn't see this asked...When replacing spark plug wires and going to install the cable in to the coils, should I strip some insulation towards the tip so the copper wire is exposed when I push it in to the coil? Or should I push the cable in with everything cut flush?

A bit of history:

Towards the end of last year I started having some POOGs like symptoms. I took apart the 'puck' in the ignition switch and cleaned it/stretched the springs, but not sure if I stretched them far enough. I also took apart the vent in the cap and it was all clean (surprisingly clean!) So I don't think that is it. I will be replacing my ground cable this year as mine snapped last year. While checking things out I noticed one of my plug boots was ripped so I was planning on replacing the plug boots with the NGK's and figured might as well replace the wires too.

Thanks, any other advice let me know. Hopefully getting the bike out of the shed next weekend!

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome