Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums - Reply to Topic
Engine / Exhaust / Cooling
\ From the radiator, through the case and out
the exhaust. If it has to do with the cooling,
engine or exhaust, discuss it here!

Thread: no resistance on clutch lever Reply to Thread
Title:
Message:
Trackback:
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:
 

Register Now



In order to be able to post messages on the Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

Once registered, your User Name"cannot be changed". We can make exceptions within 7 days, but after that, it is set in stone.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
05-10-2011 10:51 PM
Journey The clutch cable instructions mentioned rotating the clutch clockwise, is that correct? I can rotate the lever counter clockwise as if the clutch cable was pulling the lever and get tension but how do you connect the clutch cable?
05-09-2011 05:19 PM
ifixf18s You said the clutch dont engage using the handle but you can engage it at the clutch release lever? You had to remove the front bevel gear case to remove your engine. When you did that you should of seen a rod sticking out of the engine, This is the clutch push rod. I just went thru a stator replacement and my clutch release lever (the thing the cable attatches to) got turned a few times and the pin that the lever moves got misplaced. It has a gear on one side and the movement of the clutch release lever moves this pin in and out engaging the clutch push rod. what i had to do to fix mine was reengage the gears on the pin with the lever, spin the lever so the pin retracted all the way then i was able to install my gear case. ( my problem was the pin was out to far and i could not install the bevel gear case). I removed the clutch release lever spun the shaft so it would ingage the pushrod then reinstalling the lever, there is a thick line on the bevel gear case that has to be lined up with the gap on the clutch release lever. Hopefully my problem helps explain how it works, and you can figure it out from here. Does the lever spin easy as if you were pulling on the clutch? it should be really hard to move with your hand.
05-09-2011 11:18 AM
Journey
no resistance on clutch lever

I recently removed the engine and replaced the stator and didn't remove the drive section of the clutch. When installing the clutch cable I noticed the clutch lever doesn't have any resistance to pull the cable. Is there a hydraulic lifter that applies the pressure. I can manually rotate the lever and the clutch will engage/disengage.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

 
For the best viewing experience please update your browser to Google Chrome