Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums - View Single Post - Need help after lowering
View Single Post
post #1 of (permalink) Old 08-11-2007, 08:38 PM Thread Starter
BVP
Member
 
Join Date: Mar 2007
Location: Lompoc, CA
Posts: 42
iTrader: (0)
 
Need help after lowering

I had a pair of lowering brackets made and I installed them on the bike. The new height is perfect since I am only 5’6”. As I was making some turns today I notice a scraping noise. My first thought was it was the Dynas I put on, but then realized it was the center stand hitting the ground in the turns. Has anyone else had this problem and if so what did you do about it. I figure my choices are 1. Don’t lean so much in the turns (this makes for very wide turns), 2. Remove the center stand (this will cause a bit of inconvenience during those times when I need to center stand the bike), 3. Raise the bike back up to stock (which I would rather not do).

Bob
Lompoc, CA
96 VN750 Red/Black
Dyna Mufflers
Cheap Windshield
33+K miles
BVP is offline  
 
 
For the best viewing experience please update your browser to Google Chrome