The relay that's in the bike now is made by Nippondenso and reads as follows:
FA249ED 12.8v 85c/m
066500-0213 TURN SIGNAL
21(23)W x 2 + 3.4W
21(23)W MAX. 4 BULBS
(A) 79002 DOT
Can anyone out there verify this is the correct part?
The circuit on the bike checks out fine from the relay out to the lights.
I know this because applying 12v to that circuit allows the turn signals,
(and hazards) to operate correctly with the switch. So I know the circuit
is fine from the relay out to the lights. I don't know if the circuit is good
going into the relay, or if the relay itself is bad, or just not correct for the
bike. I suppose these are cheap enough to just go buy a replacement, but
this is not my bike and I'd like to be certain before spending someone elses money....