Ok, I was getting ready to do the stator mod on my bike (cause I refuse to pay $500...ok, I can't afford it) and I went to test fit the machine screws into the stator to get an idea of how the depth thing was going to work out. I soon realized that the 6mm machine screws are not going to work on the stator I bought....they were too small. I pestered my wife to find me a ruler that had mm on it and measured the holes on the stator...just a hair under 7mm. Am I going to be able to do this mod using bigger screws, or is this going to cause problems along the way? Thoughts, ideas, tips, and donations of a new engine would be much appreciated.
Now where did this piece come from???