Ok a while back, at work i custom fabricated a set of rear turn signal re-location brackets, based on the F/S design. The only difference is, these dont have the drop down tab for mounting the saddlebag supports. (thou u can easily weld a bracket on to it).
I had these on my bike for about a week, then i bought my hard saddle bags and needed the support brackets, and of course i had to buy the whole kit. So i ended up buying the whole F/S kit, and took these off, and they have been sitting in a box for over a year.
At one time I was going to start fabricating up custom F/S saddle bag supports and turn signal re-locator brackets. So i kept these for a mock up. Now i have all my dimensions and blueprints for when i actually do start making them, if there is even a big enough demand.
But for now, i will just try to sell these.
They are Nickel plated, not chromed... it will resist rusting for a while, but eventually will rust, but u can always re-paint them.
I took some pics, and will be posting them up soon.
For now I am asking $25 + shipping.
I take Paypal.
As u can see in the pics, there are 4 tapped holes (10-24NC, and i will provide some stainless steel flat heads).
There are 4 tapped holes, so unlike the F/S ones, the one side you wont have to flip the helmet lock over and have it upside down.
Also, on the inside of the piece, it has my named stamped into it... i did this at work and had to stamp my name into it so when it went to plating they knew who it belonged to.
These are my first set, my prototype, they aren't the best but they do work.
Later on, once i get my bigger garage and more tools, i plan on making these and the saddlebag support, if there is enough demand for them.