Junior Member
|
LinkBack | Thread Tools | Display Modes |
speedometer
anyone switch to a single guage? clean up the clutter a little on the "dash"? maybe move the ignition switch.
Sponsored Links | |||
Advertisement
|
|
Quote:
Originally Posted by rjw74
View Post
anyone switch to a single guage? clean up the clutter a little on the "dash"? maybe move the ignition switch.
Too much work for a too simple (but clean) appearance....
WilliamTech

-Purchased 2008 w/8800mi
Replaced ALL Cables . Kuryakyn LED Voltmeter
SilverStar Ultra 9003/HB2 H4 Headlamp, Jardine Fwd Controls,
Iridiums DPR7EIX-9 & Wires, Tuxedo Mod, Coil Mod, P/U Sensor Mod, Fork Seals,
Splines Lubed - 11/4/2012 - MF AGM Battery
Additional Flashing LED Brake Light on Trunk
Dampers went out @ 13+K !
After TOC MCCT's..... so amazingly quiet I discovered a rattling heat shield on my stock exhaust !
...have a vulcan good day!
don't remember thread but in build section guy did a couple of mods "pain killer" think he called it.
|
|
I actually went back to stock clocks/gauges, apart from liking the look of the stock ones, the previous owner had put smaller ones on my bike, temperature gauge didn't work and the speedo was far from accurate and made a real mess of the wiring. In saying that they all looked like $5 eBay specials.
I've swapped out gauges before on other projects and used a single gauge made by Acewell, had everything combined onto one dial. Wasn't cheap, but you get what you pay for
I've swapped out gauges before on other projects and used a single gauge made by Acewell, had everything combined onto one dial. Wasn't cheap, but you get what you pay for

Man can not live by bread alone... he needs Duct tape & WD40

Junior Member
Quote:
Originally Posted by Gaz73
View Post
I actually went back to stock clocks/gauges, apart from liking the look of the stock ones, the previous owner had put smaller ones on my bike, temperature gauge didn't work and the speedo was far from accurate and made a real mess of the wiring. In saying that they all looked like $5 eBay specials.
I've swapped out gauges before on other projects and used a single gauge made by Acewell, had everything combined onto one dial. Wasn't cheap, but you get what you pay for
I've swapped out gauges before on other projects and used a single gauge made by Acewell, had everything combined onto one dial. Wasn't cheap, but you get what you pay for


Sponsored Links | |
Advertisement
|
|
Bookmarks |
«
Previous Thread
|
Next Thread
»
Thread Tools | |
Show Printable Version Show Printable Version
Email this Page Email this Page
|
|
Display Modes | |
|
Posting Rules | |