How much vibration its acceptable - potential 93 vn 750 owner question - Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums
VN750 General Discussion

 
LinkBack Thread Tools Display Modes
post #1 of 2 (permalink) Old 08-25-2011, 11:53 AM Thread Starter
Junior Member
 
Join Date: Aug 2011
Posts: 7
iTrader: (0)
 
Cool How much vibration its acceptable - potential 93 vn 750 owner question

Hi there, I'm looking at a 93 vn750 with 14k on the clock. The bike seems to run perfect, shifts thru all gears casually and at speed perfectly. Did some parking lot turns in first gear and very easy to handle, noticed its minutely easier to turn to the left but all in all it seems flawless.

The only thing I could be picky about is the vibration, couldn't see much in the mirrors around 30 mph. Noticed a slight, but old, oil wetness just below the rubber acordian boot where the shaft takes from the transmission.

I've done a bit of reading and the owner said he changed the oil at the wheel. He has had the engine out so I have a feeling the mounts may be tight causing the vibration in the mirrors and bars (however it didnt feel uncomfortable, nothing violent)

The bike starts with full choke and idles perfect without choke after its warm.

What should I check before pulling the trigger?

Thanks much-
Matt
211vn is offline  
Sponsored Links
Advertisement
 
post #2 of 2 (permalink) Old 08-25-2011, 05:24 PM
Calif Rider
 
weh44att's Avatar
 
Join Date: Jan 2006
Location: Petaluma Calif
Posts: 725
iTrader: (0)
 
I would think that most of the people on this sight would say that there should not be that much viration that you can not see much in the mirrors at thirty. You can ask the owner what was the engine out for and who did it. If the timing marks were not put together just right there can be a sugnificant vibration caused by the improper alienment. The balance dampeners could also be bad and are about to completely give way and then that is a bigger problem.

2004 25,500 miles
Led tail light enhancement
Homemade floor boards
Headlight modulator
Extra heat sink on R+R
R+R relocation
Homemade driver's backrest
Fused Stator
Mcct conversion-cost 4.50
Ride-on in tires
crash bar with home made hyway pegs
iridium plugs
home made fork wind deflectors
coil pickups adjusted.
Kenda kruz tires 110/90 170/80
weh44att is offline  
Sponsored Links
Advertisement
 
Reply

Bookmarks

Quick Reply
Message:
Options

Register Now



In order to be able to post messages on the Kawasaki Vulcan 750 Forum : Kawasaki VN750 Forums forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

Once registered, your User Name"cannot be changed". We can make exceptions within 7 days, but after that, it is set in stone.

User Name:
Password
Please enter a password for your user account. Note that passwords are case-sensitive.

Password:


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:
OR

Log-in










Thread Tools
Show Printable Version Show Printable Version
Email this Page Email this Page
Display Modes
Linear Mode Linear Mode



Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On

 
For the best viewing experience please update your browser to Google Chrome